Operation Manual

IP Services Commands
IP Services Commands
8 – 125
Examples The following command enables all SNMP versions:
MX# set snmp protocol all enable
success: change accepted.
See Also
● set ip snmp server on page 8-111
● set snmp community on page 8-116
● set snmp notify target on page 8-121
● set snmp notify profile on page 8-118
● set snmp usm on page 8-126
● show snmp status on page 8-142
set snmp security
This command is deprecated in MSS Version 7.0.
set snmp trap
This command is deprecated in MSS Version 4.0. To enable or disable SNMP notifications, configure a
notification profile. See set snmp notify profile on page 8-118.
set snmp traplog
Records traps sent by the SNMP agent as an index of oldest and newest trap occurence.
Syntax set snmp traplog mode {enable | disable}
Defaults None
Access Enabled
History Introduced in MSS 7.1
set snmp traplog filter
Controls the content of the SNMP traplog.
Syntax set snmp traplog filter {log | ignore} {all | notify_name}
Defaults None
Access Enabled
History Introduced in MSS 7.1
set snmp trap receiver
This command is deprecated in MSS Version 4.0. To configure an SNMP notification target (also
called trap receiver), see set snmp notify target on page 8-121.