Operation Manual

IP Services Commands
IP Services Commands
8 – 123
SNMPv2c with Informs
To configure a notification target for informs from SNMPv2c, use the following command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string inform [profile profile-name] [retries num][timeout num]
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap
[profile profile-name]
SNMPv1 with Traps
To configure a notification target for traps from SNMPv1, use the following command:
Syntax set snmp notify target target-num ip-addr[:udp-port-number]
v1 community-string
[profile profile-name]
target-num ID for the target. This ID is local to the MX and does not need to
correspond to a value on the target. You can specify a number from 1
to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify the
notification types to send or drop.
retries num Specifies the number of times the MSS SNMP engine resends a
notification that has not been acknowledged by the target. You can
specify from 0 to 3 retries.
timeout num Specifies the number of seconds MSS waits for acknowledgement of a
notification. You can specify from 1 to 5 seconds.
target-num ID for the target. This ID is local to the MX and does not need to
correspond to a value on the target itself. You can specify a number
from 1 to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify the
notification types to send or drop.
target-num ID for the target. This ID is local to the MX and does not need to
correspond to a value on the target. You can specify a number from 1
to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify the
notification types to send or drop.