Operation Manual

Access Commands
Mobility System Software Command Reference Guide
Version 7.3
3 – 16
● set confirm on page 4-26
quit
Exit from the CLI session.
Syntax quit
Defaults None.
Access All.
History Introduced in MSS 1.0.
Examples To end your session, type the following command:
MX> quit
set enablepass
Sets the password that provides enabled access (for configuration and monitoring) to the MX
switch.
Syntax set enablepass
Defaults None.
Access Enabled.
History Introduced in MSS 1.0.
Usage After typing the set enablepass command, press Enter. If you are entering the first
enable password on this MX, press Enter at the Enter old password prompt. Otherwise, type the
old password. Then type a password of up to 32 alphanumeric characters with no spaces, and
reenter it at the Retype new password prompt.
Examples The following example illustrates the prompts that the system displays when the
enable password is changed. The passwords you enter are not displayed.
MX# set enablepass
Enter old password: old-password
Enter new password: new-password
Retype new password: new-password
Password changed
See Also
● disable on page 3-15
● enable on page 3-15
Note:
The enable password is case-sensitive.
!
Caution
Be sure to use a password that you can remember. If you lose the enable password,
the only way to restore it returns the MX to the default settings and erases the
configuration.