Operation Manual

IP Services Commands
IP Services Commands
8 – 113
Syntax set ip telnet port-num
Defaults The default Telnet port number is 23.
Access Enabled.
History Introduced in MSS Version 1.0.
Examples The following command changes the Telnet port number on an MX to 5000:
MX# set ip telnet 5000
success: change accepted.
See Also
● clear ip telnet on page 8-95
● set ip https server on page 8-109
● set ip telnet server on page 8-113
● show ip https on page 8-137
● show ip telnet on page 8-139
set ip telnet server
Enables the Telnet server on an MX.
Syntax set ip telnet server {enable | disable}
Defaults The Telnet server is disabled by default.
Access Enabled.
History
Usage
The maximum number of Telnet sessions supported on an MX is eight. If SSH is also
enabled, the MX can have up to eight Telnet or SSH sessions, in any combination, and one console
session.
Examples The following command enables the Telnet server on an MX:
MX# set ip telnet server enable
success: change accepted.
port-num TCP port number.
W arning!
If you disable the Telnet server, Telnet access to the MX is also disabled.
enable Enables the Telnet server.
disable Disables the Telnet server.
Version 1.0 Command introduced
Version 2.1 Default changed from enabled to disabled.