Operation Manual

Access Commands 3 – 15
3
Access Commands
Use access commands to control access to the Mobility Software System (MSS) (CLI). This
chapter presents access commands alphabetically. Use the following table to locate commands in
this chapter based on their use.
disable
Changes the CLI session from enabled mode to restricted access.
Syntax disable
Defaults None.
Access Enabled.
History Introduced in MSS 1.0.
Examples The following command restricts access to the CLI for the current session:
MX# disable
MX>
See Also enable on page 3-15
enable
Places the CLI session in enabled mode, which provides access to all commands required for
configuring and monitoring the system.
Syntax enable
Access All.
History Introduced in MSS 1.0.
Usage MSS displays a password prompt to challenge you with the enable password. To enable a
session, your or another administrator must have configured the enable password to this MX with
the set enablepass command.
Examples The following command plus the enable password provides enabled access to the CLI
for the current sessions:
MX> enable
Enter password: password
MX#
See Also
● set enablepass on page 3-16
Access Privileges enable on page 3-15
set enablepass on page 3-16
disable on page 3-15
quit on page 3-16