User's Manual
Table Of Contents
- So what is a gateway?
- So how Do I figure out the Subnet Mask?
- So how does this IP thing work?
- What do you mean by a routable subnet?
- So what is a Router?
- Connecting Multiple Clients to the Internet using NAT
- Examples
- Public IP’s to less than 10 Clients Through One Radio
- Public IP’s to multiple Clients Through One Radio
- Product Quality
- Service and Environment
- Additional Comments
- About You (optional)
202020
Note
:
Many Ethernet devices do not auto-negotiate properly. If you see large numbers of
dropped pings, you may have collisions. Try locking the device at 10/half as a
troubleshooting step. If the packet losses stop, step up to 100/full. If the device the
radio is connecting cannot support 100/full, you should replace the device or place
a switch in line.
WAN:
Enter the information related to the WAN interface: IP
Address, Subnet Mask, Gateway, DNS1, DNS2, and
Domain Name.
Routing:
Enables NAT, QoS, and Static Routes. NAT should
always be enabled when using private addressing.
Click on QoS or Static Routes to configure.
Port Management:
Check the box and click Apply to enable port filtering
and port forwarding. Click on any item to open the
configuration window.
LAN:
Enter the information related to the LAN interface: IP
address and subnet mask.
DHCP Server:
Check the box and click Apply to enable this feature.
Click on the item (which now appears as a link) to
open the DHCP Server configuration window.
Ethernet Port Speed:
Set as Auto by default.