User's Manual
Table Of Contents
- So what is a gateway?
- So how Do I figure out the Subnet Mask?
- So how does this IP thing work?
- What do you mean by a routable subnet?
- So what is a Router?
- Connecting Multiple Clients to the Internet using NAT
- Examples
- Public IP’s to less than 10 Clients Through One Radio
- Public IP’s to multiple Clients Through One Radio
- Product Quality
- Service and Environment
- Additional Comments
- About You (optional)
101010
Security
In this section you can configure both basic and advanced security settings for
your device.
Basic Security Settings
In this window you can define WEP parameters. WEP provides security by
encrypting data so that it’s protected when transmitted from one point to another.
Enabled:
Check to turn on WEP security protocol.
Authentication:
Select your system to be open or shared. Open is
always recommended.
Key Length:
This is the level of encryption. Note that 64 bit is
referred to as 40 bit on some systems.
Default Key:
Select the default WEP key from the list.
Activate Keys:
Enter the four WEP keys you want to activate. Keys
must be entered in HEX only.