User's Manual
Table Of Contents
- So what is a gateway?
- So how Do I figure out the Subnet Mask?
- So how does this IP thing work?
- What do you mean by a routable subnet?
- So what is a Router?
- Connecting Multiple Clients to the Internet using NAT
- Examples
- Public IP’s to less than 10 Clients Through One Radio
- Public IP’s to multiple Clients Through One Radio
- Product Quality
- Service and Environment
- Additional Comments
- About You (optional)
777
To operate the radio in PxP mode:
1. Set one radio to Access Point and the other to Infrastructure Station.
2. Enter the same SSID on both radios.
3. Set the Channel on the access point.
4. On both radios, enter the Mac address of the opposite radio in the PxP Mac
Address field (no colons).
5. Check off PxP Mode Enabled.
Note
:
In PxP mode, the LEDs on the radios will operate the same as in Infrastructure
Station mode, with LEDs proportional to signal strength.