User's Manual
Table Of Contents
- So what is a gateway?
- So how Do I figure out the Subnet Mask?
- So how does this IP thing work?
- What do you mean by a routable subnet?
- So what is a Router?
- Connecting Multiple Clients to the Internet using NAT
- Examples
- Public IP’s to less than 10 Clients Through One Radio
- Public IP’s to multiple Clients Through One Radio
- Product Quality
- Service and Environment
- Additional Comments
- About You (optional)
333
Login into the Configuration Interface
After defining the network settings, follow these steps to login into the Tranzeo
Configuration Interface.
1. Open your Internet browser (Internet Explorer, Netscape, or Firefox).
2. In the address bar, type your IP address (default IP: http://192.168.1.100).
3. In the login dialog, enter your Username and Password (if you’re a first-
time user, follow the instructions below).
4. Click OK. You will then access the configuration interface.
If you’re a first-time user:
1. Enter the default username admin and the default password default.
2. In the Password Set/Reset window, change the Administration and
Recovery* passwords. They cannot be left as default and must be different
from each other. You can change the usernames too.
3. Click Apply to save the changes.
4. You will be prompted to enter your new username and password in the login
dialog. You will then access the configuration interface.
* The recovery username and password are used to access the Password Set/Reset
window if the administration password is lost.