User's Manual
Table Of Contents
- So what is a gateway?
- So how Do I figure out the Subnet Mask?
- So how does this IP thing work?
- What do you mean by a routable subnet?
- So what is a Router?
- Connecting Multiple Clients to the Internet using NAT
- Examples
- Public IP’s to less than 10 Clients Through One Radio
- Public IP’s to multiple Clients Through One Radio
- Product Quality
- Service and Environment
- Additional Comments
- About You (optional)
444
Step 7:
Fit the boot cover over the 4 studs and the
gasket. Secure with 4 keps nuts. Tighten
with a 3/8” wrench until the gasket is at
least 50% compressed.
Step 5:
Place the gasket—with the adhesive side
facing up—over the 4 studs around the port
of the radio. Flatten the gasket ensuring
there are no gaps. Remove the backing.
Step 8:
Make sure the cap nut of the strain relief is
tightened properly to ensure a weather-
proof seal.
IMPORTANT! Hand tighten only. Do not
over tighten as you may damage the
weather-tight seal of the strain relief.
Step 6:
Plug the Cat 5 cable inserted in the boot
cover into the port. Remember to place the
boot cover according to the desired
polarization, so that the strain relief faces
the ground.