User's Guide

Chapter 11: Ethernet Interface Configuration
TR0190 Rev. A1 67
CLI
To set the DHCP mode to ‘client’ on the Ethernet interface, set the value of the ‘dhcp.role’
parameter in the ‘eth0’ interface to ‘client’, as shown in the example below.
> use eth0
eth0> set dhcp.role=client
To disable Ethernet DHCP client mode, set the DHCP mode parameter to ‘none’ as shown
below.
> use eth0
eth0> set dhcp.role=none
Web GUI
The Ethernet DHCP mode value can be set via the web interface using the “DHCP” sub-tab on
the “DHCP” tab on the “System Parameters” page (see Figure 38).