User's Guide

Chapter 9: System Settings
TR0190 Rev. A1 57
The OnRamp utility provides network detection and configuration capabilities for EL-500s. The
configuration capabilities are only intended for initial configuration and for security reasons, it is
strongly recommended that OnRamp configuration capability is disabled after initial
configuration.
You can use the CLI, the web interface, or OnRamp to determine whether a device can be
configured from OnRamp. In OnRamp, the “Prog” column displays the programming capability
from OnRamp. A ‘Y” in this column indicates that OnRamp can configure the device, an ‘N’
indicates that it cannot.
CLI
The OnRamp configuration capability is controlled by the ‘provisioning.enable’ parameter in the
‘sys’ interface. Set this parameter to ‘0’ to disable configuration through OnRamp, as shown in
the example below.
> use sys
sys> set provisioning.enable=0
Web GUI
The OnRamp configuration capability is set on the “OnRamp” tab on the “Security” page (see
Figure 33).
Figure 33. OnRamp configuration access