User's Guide

Chapter 9: System Settings
TR0190 Rev. A1 53
CLI
The geographic location of the EL-500 can be stored in the following fields in the ‘sys’
interface:
• sys.location.gps.altitude
• sys.location.gps.latitude
• sys.location.gps.longitude
For example, you can set the latitude value as follows.
> use sys
sys> set location.gps.latitude=”34.01”
A description of the EL-500’s location can be stored in the ‘location.postal’ field in the ‘sys’
interface. For example, you can set the location value as shown below.
> use sys
sys> set location.postal=”Light post near 123 Main St., Anytown, CA”
Web GUI
The location information can be set via the web interface using the “Location” tab on the
“System Parameters” page.
Figure 29. Setting location and certificate information