User's Guide

Chapter 9: System Settings
TR0190 Rev. A1 52
The contact person and location of the device located via SNMP are set with the
‘snmp.contact. and ‘snmp.location’ parameters in the ‘sys’ interface as shown below.
> use sys
sys> set snmp.contact=”Joe Smith”
sys> set snmp.location=”123 Main St., Anytown, USA”
Web GUI
The SNMP-related parameters can be set on the “SNMP” tab on the “System” page (see
Figure 28).
Figure 28. SNMP configuration
9.7 Location
Two types of device location information can be stored:
• Latitude/longitude/altitude
• Postal address or description a device’s location
Note that these values are not automatically updated and must be entered after a device has
been installed. Altitude is in meters. Latitude and longitude must be given as geographic
coordinates in decimal degrees, with latitude ranging from -90 to 90 (with negative being south,
positive being north) and longitude ranging from -180 to 180 (with negative being west, positive
being east).