User's Guide

Chapter 6: Status Information
TR0190 Rev. A1 35
6.2 Interface Status
Traffic and neighbor information for the virtual AP and wired interfaces are available on the
“Status” tab of the “Status” page. Select the appropriate interface for which you wish to view
information from the row of tabs below the primary tab row.
6.2.1 Virtual AP Interfaces
The sub-tabs display status information about the virtual AP interfaces. Data statistics
information for the interface are displayed, showing received and transmitted data in terms of
bytes and packets.
On the “wlan” sub-tabs, the client devices connected to the virtual APs are displayed. The
following information is displayed for each client device:
• MAC address
• IP address
• Quantity of data received from the client device and transmitted to the client device
• Received signal strength (RSSI) in dBm and in parentheses the associated signal level
based on a noise floor of -96dBm
• Time since last reception from the device
• A summary of the capabilities of the client device’s radio card
Figure 11. Status information for one of the virtual AP interfaces