User's Manual
TR-MX5
4
Safety
Information
FCC Compliance
This device has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the device is operated in a residential
environment. This device generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the user guide, may cause harmful interference to
radio communication. In case of harmful interference, the users will be required to correct
the interference at their own expense.
The users should not modify or change this device without written approval from Tranzeo
Wireless Technologies. Modification will void warranty and authority to use the device.
For safety reasons, people should not work in a situation where RF exposure limits could be
exceeded. To prevent this situation, the users should consider the following rules:
Install the antenna so that there is a minimum of 100cm (39.37”) of distance between
the antenna and people.
Do not turn on power to the device while installing the antenna.
Do not connect the antenna while the device is in operation.
Do not collocate or operate the antenna used with the device in conjunction with any
other antenna or transmitter.
Professional Installation Required
The product requires professional installation. Professional installers ensure that the
equipment is installed following local regulations and safety codes.
Within the 5.15–5.25 GHz band, UNII devices are restricted to indoor operations only to
reduce any potential for harmful interference to co-channel MSS operations and
prohibited from being operated on this band outdoors. This device has been designed to
operate with the antennas listed below and having a maximum gain of 11 dBi. Antennas
not included in this list or having a gain greater than 11 dBi are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms.
MME5-11: 5GHz 11dBi 2x2 directional panel antenna
Industry Canada Compliance
Operation of this device is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.