User's Manual

TR-MX2
30
LED INTERPRETATION
The state of the LEDs on the TR-MX2 is a useful diagnostic and system monitoring tool.
Dependent on the mode of use of the TR-MX2 the following tables enable the
correct interpretation of the LED states.
TR-MX2 LEDs
CPE MODE
LED
INTERFACE
ON
OFF
BLINKING
1
Power
Unit is Powered ON
Unit is Powered OFF
-
2
Ethernet
Ethernet Linked
No Ethernet Link
Traffic
3
Wireless
Wireless Linked
No Wireless Link
Traffic
4
RSSI
RSSI > -85dBm
RSSI < -85dBm
-
5
RSSI
RSSI > -75dBm
RSSI < -75dBm
-
6
RSSI
RSSI > -65dBm
RSSI > -65dBm
-
Note: the RSSI thresholds are user configurable.
AP MODE
LED
INTERFACE
ON
OFF
BLINKING
1
Power
Unit is Powered ON
Unit is Powered OFF
-
2
Ethernet
Ethernet Linked
No Ethernet Link
Traffic
3
Security
Wireless Linked
No Wireless Link
Traffic
4
Wireless
5 GHz
2.4 GHz
-
5
Wireless
ACL enabled
ACL disabled
-
6
WDS
WDS Enabled
WDS Disabled
-
Note: The wireless/radio LEDs is applicable only to the first active AP if there
are multiple VAPs (Virtual APs).
LED 1
LED 6