User's Manual

Step 2:
Connect an Ethernet cable form the PC/Laptop to the PC connector on the POE LAN port.
Step 3:
Connect an Ethernet cable from the TR-MX2 unit to the POE port on the POE.
Note: On the TR-MX2, there are two Ethernet ports. It is highly recommended to use the
Ethernet port closest to the reset pin as the primary use port. This is the active port used to
load new firmware from power on state in the event a firmware recovery procedure is
necessary. The other port would be recommended port for daisy chaining
Step 4:
Connect a PC to the “LAN” Port of the POE, with a straight through Ethernet cable.
Note: Connect the radio to the “POE” port and the “LAN” port to PC/switch/router.
Power the POE unit with the supplied cord, and ensure power source has earth pin.
Step 5
Connecting to the TR-MX2 AP
Before accessing the configuration interface, you have to change the network connection
settings in your computer to be on the same subnet as the radio. Alternatively, you could use the
Victor Utility program to assign the radio a temporary IP alias that is on the same subnet as your
computer.