User's Manual

TR-MX2 QUICK INSTALL GUIDE
Installing the Ethernet Cable into the TR-MX2
Install using straight through Ethernet cables
Summary Steps
1.
Remove Bottom Cover as described above
2.
Connect a PC/laptop to Ethernet/LAN port of the POE
3.
Connect an Ethernet cable from the powered RJ45 POE port to TR-MX2
4.
Power the POE unit with the supplied power adaptor (connect only to a grounded outlet)
5.
Configure PC with a static IP address in the same subnet of the TR-MX2 (192.168.1.x) like
192.168.1.101
6.
From a web browser, connect to the configuration page http://192.168.1.100
(username/password as below)
Step 1:
Hold unit with release tabs facing up and the cover away from you.
Push down release tab at one end and pull away that corner with the other hand, just over the catch
clip, leaving about a 2mm gap. Do the same on the other end and the cover can be pulled off easily to
reveal the dual Ethernet ports and Reset pin. Ensure that the black cable inserts remain in place and do
not fall out.
Mount the TR-MX2 on a suitable pole with the supplied straps as shown
.