User's Manual
20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone (604) 460-6002 Fax (604) 460-6005
www.tranzeo.com
Revision 7/26/04 Build 51 Page 8 of 10
TRANZEO WIRELESS QUICK START GUIDE
IP Address
Mode Select Static to enter a valid Static IP or select DHCP
address for auto select.
IP Address This field is Read Only if DHCP is selected
Subnet Mask This field is Read Only if DHCP is selected
Gateway This field is Read Only if DHCP is selected
Radio
Firmware Lists Diagnostic Information about internal firmware
MAC Address Radio MAC Address
Service Set
SSID The SSID is a unique ID given to an Access Point.
Wireless clients associating to the Access Point must
have the same SSID. The SSID can have up to 32
characters.
TX Rate The rate at which the radio will communicate with the
AP. NOTE: Setting this rate below the maximum
possible does not limit bandwidth, and often has a
negative impact on the operation of your network.
Ad – Hoc / Infrastructure Select Infrastructure for any WISP operation
Channel Only applicable in Ad-Hoc Mode
AP Density Best set to Low in most WISP applications
RTS Threshold (0-3000) Select RTS that works best in your location. A
general rule of thumb is the more clients you have, the
lower the value should be set.
Fragmentation Threshold (256-2346) Select Fragmentation that works best in your location.
The lower the Fragmentation, the smaller the packets.
Security
Enabled Turn On WEP
Key Length Level of Encryption.
NOTE: 64 bit is called 40 bit on some systems
Encrypted Data only Only Connect to a system if WEP is enabled
Shared Key Authentication Turn on Shared Key Authentication
Keys
Enter your WEP keys. NOTE: Keys must be
entered in HEX only.