User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 7/26/04 Build 51 Page 5 of 10
TRANZEO WIRELESS QUICK START GUIDE
Step 4
Place the Ethernet boot over the 4 Screw Posts. The screws should just
barely clear the tightening bracket. Apply 4 Ket nuts to the screw posts
and tighten until the metal plate makes full contact with the Ethernet
boot. Do not over tighten.
This is an example of over tightening. Over tightening connections like
this may crack the boot and will compromise the gasket seal. Over
tightening is not covered by warranty.
Attaching the Mounting Bracket
As shown below, the U-Bolt is designed to mount around a pole.
Tighten bolts sufficiently to prevent any movement.
Down or up tilt can be adjusted by swinging the unit before tightening
the U-Bolt.