User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 7/26/04 Build 51 Page 4 of 10
TRANZEO WIRELESS QUICK START GUIDE
Connecting the Ethernet Cable
Step 1
Place the Ethernet Boot Cover over the end of your Cat 5 Cable.
Step 2
Step 3
Insert the Cat 5 Cable and tighten the Boot Cover. Be sure to pull
enough cable through to reach the RJ-45 connector with an RJ-45 jack
attached.
Hand tighten only. DO NOT OVERTIGHTEN as you may damage the
environment seal.
A
ttach tightening bracket on
top of the Ethernet Boot. This
is easiest to do before you attach the CAT 5 cable. The
Gasket must be attached to the Boot so that it sits between
the radio and the boot.