User's Manual
20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone (604) 460-6002 Fax (604) 460-6005
www.tranzeo.com
Revision 7/26/04 Build 51 Page 3 of 10
TRANZEO WIRELESS QUICK START GUIDE
2-4 Hardware Installations
Take the following steps to set up your TR-CPE200.
Site Selection: Before installation, determine the TR-CPE200 Units location. Proper placement of the unit is
critical to ensure optimum radio range and performance. You should perform a Site Survey to choose a proper
placement for your unit. Place your unit within the line of sight of the Access Point. Obstructions may impede
performance of the unit.
Tools Required to Install
• One 3/8 wrench
• One RJ-45 Crimper
• A suitable length of Cat 5 Cable to bring the signal from the unit to the Power over Ethernet Adaptor
• RJ-45 Jacks
Before installing, you must determine if you will be installing the unit in a horizontal or vertical orientation.
The TR-CPE200 model can be mounted in either orientation. The Ethernet boot should always be placed so
that the cable runs toward the ground for maximum environmental protection.
Vertical Orientation Horizontal Orientation