User's Manual

Unit 13 – 11720 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 9E7
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 5/1/2003 Page 8 of 20
Tranzeo TR-CPE
Quick Start Guide
Step 4
Place the Ethernet boot over the 4 Screw Posts. The screws should just barely
clear the tightening bracket. Apply 4 Ket nuts to the screw posts and tighten until
the metal plate makes full contact with the Ethernet boot. Do not over tighten.
This is an example of over tightening. Over tightening connections
like this may crack the boot and will compromise the gasket seal.
Over tightening is not covered by warranty.