User's Manual

Unit 13 – 11720 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 9E7
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 5/1/2003 Page 7 of 20
Tranzeo TR-CPE
Quick Start Guide
Connecting the Ethernet Cable
Step 1
Place the Ethernet Boot Cover over the end of your Cat 5 Cable.
Step 2
Step 3
Insert the Cat 5 Cable and tighten the Boot Cover. Be sure to pull
through enough cable to reach the RJ-45 connector with an RJ-45
jack attached.
Hands tighten only. DO NOT OVERTIGHTEN as you may damage
the environment seal.
Attach tightening bracket around on top of the Ethernet
Boot. This is easiest to do before you attach the CAT 5
cable.