User's Manual

Unit 13 – 11720 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 9E7
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 5/1/2003 Page 6 of 20
Tranzeo TR-CPE
Quick Start Guide
Installing the TRANZEO TR-CPE
Take the following steps to set up your TRANZEO CPE.
Site Selection
Before installation, determine the TR Units location. Proper placement of the unit is critical to ensure
optimum radio range and performance. You may use the Site Survey and Access Points Browser utility (The
utilities included with the wireless PC Card) to choose a proper placement for your unit. Place your unit
within the line of sight of the Access Point. Obstructions may impede performance of the unit.
Tools Required to Install
• One 3/8 wrench
• One RJ-45 Crimper
• A suitable length of Cat 5 Cable to bring the signal from the unit to the Power over Ethernet Adaptor
• RJ-45 Jacks
Before installing, you must determine if you will be installing the unit in a horizontal or vertical orientation.
The TR CPE model can be mounted in either orientation. The Ethernet boot should always be placed so
that the cable runs toward the ground for maximum environmental protection.
Vertical Orientation Horizontal Orientation