User's Manual

Unit 13 – 11720 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 9E7
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 5/1/2003 Page 12 of 20
Tranzeo TR-CPE
Quick Start Guide
Assigning the Adapter’s Name
Assign specificity a unique name for the TR-CPE.
Assigning the Rate
TR-CPE provides various data rate options for you to select. Data rates options include 1 Mbps, 2
Mbps , 5.5 Mbps , 11 Mbps, and Auto. In most networking scenarios, you will see that the factory-set
default “Auto” will prove the most throughput.
Assigning the IP Address
Assign an IP address to your TR-CPE if you wish to configure the TR-CPE via the Web Management.
Consult your network administrator to obtain an available IP address (
the default IP address is
192.168.1.1). For further setup please refer to the following section.
Assigning the subnet mask
Assign a subnet mask to your TR-CPE if you wish to configure the TR-CPE via the Web Management.
Consult your network administrator to obtain an available subnet mask. For further setup please refer to
the following section.
Assigning the default gateway
Assign a default gateway to your TR-CPE if you wish to configure the TR-CPE via the Web
Management. Consult your network administrator to obtain an available default gateway.
Password
It is highly recommended tha t you assign a new password to your TR-CPE for safety issue. Enter the
new password in the New Password and Confirm Password fields respectively.
After setting the parameters, click the
APPLY
button to make the changes take effect. To return the previous
page, click the CANCEL button.
Default
You may click on Default button to enable you to restore the TR-CPE’s default settings.
SECURITY:
To prevent unauthorized wireless stations from accessing data transmitted over the network, the TR-CPE
offers the following levels of security options.
- Data Encryption, known as WEP (Wired Equivalent Privacy), encrypts wireless data transmitted via
wireless medium.
Click the Security page you will see the current security status of the TR-CPE. Click the SETUP button
and you may then enable the security function.