User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 11/30/2004 Build 22 Page 5 of 19










2-4 Hardware Installations
Take the following steps to set up your TR-AP-5amp-N.
Site Selection: Before installation, determine the TR-AP-5amp-N Units location. Proper placement of the unit
is critical to ensure optimum radio range and performance. You should perform a Site Survey to choose a
proper placement for your unit. Place your unit within the line of sight of the Access Point. Obstructions may
impede performance of the unit.
Tools Required to Install
• One 3/8 wrench
• One 3/4 wrench
• One RJ-45 Crimper
• A suitable length of Cat 5 Cable to bring the signal from the unit to the Power over Ethernet Adaptor
• 2 RJ-45 Jacks
Before installing, you must determine if you will be installing the unit in a horizontal or vertical orientation.
The TR-AP-5amp-N model can be mounted in either orientation. The Ethernet boot should always be placed so
that the cable runs toward the ground for maximum environmental protection.