User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Revision 11/30/2004 Build 22 Page 7 of 7










Step 4
Step 5
Step 6
Place the Ethernet boot over the 4 Screw Posts. The screws should just
barely clear the tightening bracket. Apply 4 Ket nuts to the screw posts
and tighten until the gasket makes full contact with the Ethernet boot.
Do not over tighten.
Attach optional tightening bracket on top of the Ethernet
Boot. This is easiest to do before you attach the CAT 5
cable. The Gasket must be attached to the Boot so that it
sits between the radio and the boot.
Insert the Cat 5 Cable and tighten the Boot Cover. Be sure
to pull enough cable through to reach the RJ-4
5 connector
with an RJ-
45 jack attached. Attach tightening bracket on
top of the Ethernet Boot. This is easiest to do before you
attach the CAT 5 cable. The Gasket must be attached to the
Boot so that it sits between the radio and the boot.
Hand tight
en only. DO NOT OVERTIGHTEN as you may
damage the environment seal.