User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Page 8 of 24 3/10/2005












Step 7
Attaching the Mounting Bracket
Place the Ethernet boot over the 4 Screw Posts. The screws
should just barely clear the tightening bracket. Apply 4
Keep nuts to the screw posts and tighten until the gasket
makes full contact with the Ethernet boot. Do not over
tighten.
This is an example of over tightening. Over tightening
connections like this may crack the boot and will
compromise the gasket seal. Over tightening is not covered
by warranty.
As shown below, the U-Bolt is designed to mount around a
pole. Tighten bolts sufficiently to prevent any movement.
Down or up tilt can be adjusted by swinging the unit before
tightening the U-Bolt.