User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Page 7 of 24 3/10/2005












Step 4
Step 5
Step 6
Attach the Gasket to the Boot so that it sits between the
radio and the boot.
Insert the Cat 5 Cable and tighten the Boot Cover. Be sure
to pull enough cable through to reach the RJ-45 connector
with an RJ-45 jack attached. The Gasket must be attached
to the Boot so that it sits between the radio and the boot.
Hand tighten only. DO NOT OVERTIGHTEN as you may
damage the environment seal.
Repeat steps 2 & 3 to attach the second Ethernet Cable
lock.
If you are not going to be using the second port make sure
that it is tightened down to ensure a weather-tight seal.