User's Manual

20155 Stewart Crescent,
Maple Ridge, B.C. Canada V2X 0T6
Phone [phone] Fax [phone]
www.tranzeo.com
Page 5 of 24 3/10/2005












Hardware Installation
Take the following steps to set up your TR-6000.
Site Selection: Before installation, determine the TR-6000 unit’s location. Proper placement of the unit is
critical to ensure optimum radio range and performance. You should perform a Site Survey to determine the
optimal location. Ensure the CPE is within line-of-sight of the Access Point. Obstructions may impede
performance of the unit.
Tools Required to Install
• One 3/8 wrench
• One 3/4 wrench
• One RJ-45 Crimper
• A suitable length of Cat 5 Cable to bring the signal from the unit to the Power over Ethernet Adaptor
• 2 RJ-45 Jacks
Before installing, you must determine if the unit will be in the horizontal or vertical orientation. The TR-6000
model can be mounted in either orientation. The Ethernet boot should always be placed so that the cable runs
toward the ground for maximum environmental protection.