User's Manual

FCC Information

This equipment has been tested and found to comply with the limits for a Class A digital

devices pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction manual, may cause harmful

interference to radio communication.

Operation of this equipment in residential area is likely to cause harmful interference in

which case the user will be required to correct the interference at this own expense.

The user should not modify or change this equipment without written approval from

company name. Modification could void authority to use this equipment.

For the safety reason, people should not work in a situation which RF Exposure limits be

exceeded. To prevent the situation happening, people who work with the antenna should

be aware of the following rules:

1. Install the antenna in a location where a distance of 20 cm from the antenna may be

maintained.

2. While installing the antenna in the location, please do not turn on the power of wireless

card.

3. While the device is working, please do not contact the antenna.

4. RF exposure: The antenna used for this transmitter must not be co-located or operating

in conjunction with any other antenna or transmitter”

reproduced, adapted, stored in a retrieval system, translated into any language, or

transmitted in any form or by any means without the written permission of the

supplier.

About This Manual

The purpose of this manual is for the setup of the 11Mbps Wireless LAN Access

Point. This manual, revised as version 3.0.0 in 2001, includes procedures assisting

you in avoiding unforeseen problems.