User's Manual

17
set mode | ip_start | ip_end | ip_netmask | ip_gateway | ip_dns1 | ip_dns2 | ip_wins1
| ip_wins2 |wizard: set the DHCP server mode and other related network parameters
for the Wireless Access Point. The definition of “dhcp set mode” command is listed
as follows:
• mode [disable/enable]: disable or enable the DHCP server function
stat: display IP addresses and MAC addresses of wireless clients.
NAT Setup
The 'nat' command contains sub-commands that allow you to manage NAT configuration
for the Wireless Access Point. All the wireless clients can access Internet with a single IP
address. Note that NAT will function only when the Wireless Access Point is set to IP
Router mode. The sub-commands are described as follows:
mode[disable/enable]: enable or disable the NAT function
stat: display status of the wireless clients