User's Manual

To change factory default settings, type “set xxx (parameter) xxxx (value) based on the

chart below. For example, set channel 7 command will set the channel to number 7; set

essid “Your Network” command will set the ESSID as Your Network. Remember that, a

‘save’ command is required for changes to take effect. Always reset your AP with the

“Reset” command.

The following is a list of parameters you can make changes on the Access Point.

Parameter Description Default Value

apname name of the unit ApXXXXXX (X's are he units MAC Address)

mode The operation mode of the unit: AP

AP- Wireless Access Point

SAI- Station Adapter Infrastructure

PxP - Inter-Building with Repeating

SAA - Station Adapter - Ad-hoc

SAA2 - Station Adapter - 802.11 Ad-hoc

channel The Radio Channel Number 1

essid The ESSID of the unit. My Network

tx_rate Transmission Rate Auto

TX_retry Mumber of retries for data transmission 7

rts_threshold The threshold (number of bytes) for enabling RTS/CTS 2432

handshake. Data withits frame size larger than this value

wil preform the RTS/CTS handshake. Range 0 - 2432

frag_threshold

The threshold (number of bytes) for the fragmentation 2432

boundary. Data will be received in fragments which its

size does not exceed this value. Range 256 - 2432

lan_speed transmission speed of the LAN port: 10/100 Mbps

Auto

save

Save your new configuration. Remember that the “save command” is required every

time you make the new configuration.

set default

Return the factory default settings of the Access Point except for the IP addresses. A

'save' command is required for changes to take effect.

cls*

Clear the console screen.

exit*

Exit the console.

or help*

Print a help screen.

rz*

Receive a firmware file by the Zmodem protocol. The console will enter Zmodem

receiving mode and then use the "file upload" function of your terminal emulation

program to upload a new firmware file (ap.img) to the Access Point. Upon

completion, always remember to type the 'reset' command for running the Access

Point with the new firmware.

reset*