Quick Start Manual

a. Enter the IP Address into the box marked IP
Address.
6. Click “Use the following IP Address” radio button.
For all information to enter into the boxes, contact your
network administrator.
b. Set the range of IP’s that you want to have given
out to the multiple computers.
a. Enter the IP address, Subnet Mask, and
Default Gateway.
i. Ensure that the subnets are the same in the
IP Address and the range of IP’s that you
wish to have assigned (the third number in
the Address).
b. Enter the preferred and Alternate DNS values
and click OK.
a.
b.
Figure 26
IF You Choose DHCP then:
Figure 29 b
If you have a DHCP Server upstream (closer to the internet),
DHCP client on the WAN side, DHCP server on the LAN side
and the DHCP client turned on on your computer all relevant
information (IP address, Gateway etc…) will be passed on.
1. Set the radio buttons to Obtain “DHCP”.
a. Click the “release” button and then click the
“renew” button. Reset the unit. Go back to
the screen and repeat if the numbers do not
show up in the box.
4. Hit Apply.
For multiple computers do the following:
b. Check the NAT (IP Sharing) through this port
box. (Fig 10 b)
a. Follow steps 1-4 and then follow below.
b. Plug the Cable coming out of the CPE into the
port marked CPE on your DC Injector.
c. Turn off PPPoE by clicking the no.
a.
b.
c.
c. Plug a cable into the port marked PC on the DC
Injector into the uplink port on the hub
d. Plug another Ethernet cable into an available port
on the hub and put the other end into the
Ethernet card in your PC. (Fig 30)
Figure 30
e. Check the connection by opening a web page
(that isn’t cached) in your browser.
f. Repeat step d. for more computers.
To check signal strength start a telnet session by going to
the Start Menu and select Run. Type in “telnet” and the IP of
the unit. Enter password. Type “stat” and hit enter. Signal
Strength is displayed across the top.
Figure 28 b
2. Close the window by hitting the close button.
3. Click the LAN on Ethernet setup button (bottom right
hand corner).
To manage the CPE from inside your network use the
gateway’s address to telnet or when using your browser. To
8