Quick Start Manual

For Windows 98 Users:
Ethernet card in your PC. (Fig 12 a)
1. Click Start button, then Settings, then Control Panel.
2. Click the network icon in the list as in Figure 15.
Figure 13 a
e. Check the connection by opening a web page (that
isn’t cached) in your browser.
f. Repeat step d. for more computers.
To check signal strength start a telnet session by going to
the Start Menu and select Run. Type in “telnet” and the IP of
the unit. Enter password. Type “stat” and hit enter. Signal
Strength is displayed across the top.
To manage the CPE from inside your network use the
gateway’s address to telnet or when using your browser. To
remotely manage the CPE (from an outside location) use the IP
address of the CPE. (Fig 13 a)
2.
3.
Figure 14 a
Figure 15
If you do not wish to have a DHCP server on the LAN side
assigning DHCP follow the steps below for EACH computer on
the CPE:
3. Select the TCP/IP icon in the list and click properties.
(Note: there is usually only one TCP/IP icon in the
list but if there is two or more select your Ethernet
card.)
1. Un check the box labeled “Enable DHCP Server
(wireless LAN)”
5