User's Manual

555
This document is intended for Public Distribution
19473 Fraser Way,
Pitt Meadows, B.C. Canada V3Y 2V4
Chapter 3: Configuration
3-5
TR-FDD Series
Tranzeo Wireless Technologies
Setup Menu
In this section you would be able to configure wireless and administrative settings
for the TR-FDD Series radio.
Wireless Settings
This window displays the wireless configuration of the device.
.
Wireless Mode:
Rx-Master / Tx-Slave or Tx-Master / Rx-Slave. One
radio of the pair needs to be set to Rx-Master / Tx-
Slave and the other radio of the pair needs to be set to
Tx-Master / Rx-Slave.
SSID:
The Service Set Identifier (SSID) is the name that
identifies a specific wireless LAN. Devices must have
the same SSID to communicate with each other. The
Master Board SSID must be set the same as the Master
Board SSID on the peer radio. The Slave Board SSID
also needs to be set to the same as the Slave Board
SSID on the peer radio.
Visibility Status:
You can set your access point to be Visible or
Invisible to clients.
Location:
You can set the location of the radio to be Outdoor or
Indoor. The available channels may differ depending
on the location.
Channel:
Select the channel that matches the channel filter you
are using with the radios.
TX Rate:
The transmission speed at which the radio and access
point communicate with each other. Basic rates must
be selected.
Note
: Setting this rate below the maximum possible
does not limit bandwidth and often has a negative
impact on the operation of your network.