User's Manual

EnRoute500 User’s Guide
TR0149 Rev. C5
49
txpower Output Power (dBm)
1 9
9 10
14 12
18 14
22 16
26 18
29 20
33 22
60 24
Table 7. Mesh radio output power settings
7.5 IP Configuration
The IP address, broadcast address, and netmask associated with the mesh radio interface can
be viewed, but not directly changed through the ‘mesh’ interface. To change the IP settings,
the ‘id’ settings in the ‘sys’ interface, from which the IP settings are derived, must be changed
(see sections 6.3 and 6.4).
The IP settings can be viewed with
> use mesh0
mesh0> get ip.address
ip.address = 172.29.2.4 [read-only]
mesh0> get ip.broadcast
ip.broadcast = 172.29.255.255 [read-only]
mesh0> get ip.gateway
ip.gateway = [read-only]
mesh0> get ip.netmask
ip.netmask = 255.255.0.0 [read-only]
The mesh radio IP settings are also available through the web interface on the “Status” page.
7.6 Neighbor Status
Information on mesh neighbors is provided on the mesh status page, accessible under the
‘Status’ tab on the ‘Status’ page. The signal strength of each neighbor device, it’s MAC
address, its IP address, and the time since data was last received from it are listed. A sample
of the mesh neighbor status page is shown in Figure 28.