User's Manual

EnRoute500 User’s Guide
TR0149 Rev. C5
33
After these settings have been changed, the EnRoute500s will be able to form a mesh cluster
and you will be able to configure the nodes from a central location. This minimal configuration
must be performed prior to deployment, but all other configuration can be carried out after
deployment.
To simplify initial configuration, the web GUI has a page that allows the user to change all the
parameters listed in this section on a single page. This page can be accessed by clicking on
the ‘Minimal configuration’ link that is present on the left-hand side of all web GUI pages.
Figure 11. Initial configuration web page