User's Manual

EnRoute50x/51x User’s Guide

TR0153 Rev. D2

addresses to the DHCP pool. You may reserve the entire range of IP addresses, but the

EnRoute500 will use at least the highest address in the range for DHCP.

If the „dhcp.reserve‟ value is non-zero, the DHCP range start address will be affected as shown

below

Start address = <LAN prefix>.

<Mesh ID>.

<Node ID>.

CLI

The examples below show how to set the DHCP server state for the „wlan1‟ interface.

> use wlan1

wlan1> set dhcp.role=server

To disable the DHCP server, set the „dhcp.role‟ parameter to „none‟

> use wlan1

wlan1> set dhcp.role=none

The example below shows how to set the DHCP reserve parameter

> use wlan1

wlan1> set dhcp.reserve=5

Web GUI

The access point and wired interface DHCP servers‟ state can be set via the web interface

using the “DHCP” sub-tab under the “DHCP” tab on the “System Parameters” page (see

Figure 36). All of the access points‟ DHCP settings can be configured on this page.

The DHCP reserve setting for all access points and the wired interface can be set via the web

interface using the “DHCP” sub-tab under the “DHCP” tab on the “System Parameters” page

(see Figure 36).