User's Manual

EnRoute50x/51x User’s Guide
TR0153 Rev. D2
47
A description of the node‟s location can be stored in the „location.postal‟ field in the „sys‟
interface. For example, you can set the location value as shown below.
> use sys
sys> set location.postal=”Light post near 123 Main St., Anytown, CA”
Web GUI
The location information can be set via the web interface using the “Location” tab on the
“System Parameters” page.
Figure 25. Setting location information
6.10 Certificate Information
A certificate for use with splash pages and the web interface is locally generated on the node.
The information embedded in this certificate can be defined by the user. A new certificate is
automatically generated when any of the following parameters are changed.
CLI
The information used in certificate generation can be set using the „organization‟ parameters in
the „sys‟ interface. These parameters are:
sys.organization.name –name of organization (must be enclosed in quotes if it contains
spaces)
sys.organization.city – city name (must be enclosed in quotes if it contains spaces)