User's Manual

EnRoute50x/51x User’s Guide

TR0153 Rev. D2

> use sys

sys> set id.node=107

Web GUI

The mesh and node IDs can be set via the web interface using the “System” tab on the

“System Parameters” page.

Figure 19. Setting the mesh and node IDs

6.4 Mesh Prefix

The mesh prefix parameter sets the first two octets of a node‟s mesh interface IP address. It

must be set the same for all nodes in a given mesh cluster. The allowed range of values is

172.16 through 172.29.

It is recommended that the mesh prefix is not changed from its default value 172.29.

CLI

The mesh prefix is set with the „id.meshprefix‟ parameter in the „sys‟ interface as shown in the

example below.

> use sys

sys> set id.meshprefix=172.29