User's Manual

EnRoute50x/51x User’s Guide
TR0153 Rev. D2
38
6 System Settings
This section describes settings that are applicable to the overall operation of the EnRoute500,
but are not related directly to a particular interface.
6.1 User Passwords
The passwords for the „admin‟ and „monitor‟ users are configurable. The default password for
both accounts is „mesh‟.
CLI
The passwords for the „admin‟ and „monitor‟ users can be set using the „password.admin‟ and
„password.monitor‟ parameters in the „sys‟ interface. The passwords will not be displayed when
using the „get‟ command with these parameters. Note that the „monitor‟ account password can
only be changed by an „admin‟ user. The example below shows how to set the „admin‟
password using the CLI.
> use sys
sys> set password.admin=newpass
Web GUI
The passwords can be changed via the web interface using the “Passwords” tab on the
“System Parameters” page. The passwords can be changed independently – if only one
password is modified, the other password will remain unchanged.
Figure 16. Passwords page