User's Manual

EnRoute50x/51x User’s Guide
TR0153 Rev. D2
25
2.5.14 ‘!’ command
Syntax
!<command history number>
!<string that matches start of previously-executed command>
!!
Description
Executes a previously-executed command based either on a command
history number or matching a string to the start of a previously-executed
command. Note that there is no space between the „!‟ and the argument.
The „history‟ command shows the command history, with a number
preceding each entry in the command history. Use this number as an
argument to the „!‟ command to execute that command from the history.
When a string is provided as an argument to the „!‟ command, the string will
be matched against the beginning of previously-executed commands and
the most recently executed command that matches will be executed.
Use „!!‟ to execute the last command again.
Example
If the command history is as follows
1: use wlan1
2: get essid
3: set essid=new_ap_essid1
4: use wlan2
5: set essid=new_ap_essid2
the command
!1
will execute
use wlan1
The command
!use
will execute
use wlan2