User's Manual

EnRoute50x/51x User’s Guide
TR0153 Rev. D2
22
2.5.8 ‘list’ command
Syntax
list
Description
Lists all parameters for the selected interface
Example
With the „firewall‟ interface selected
list
will display
firewall.gateway.enable : prevent uninitiated incoming connections
past the gateway?
firewall.node.allowc2c.eth0 : allow clients to see each other if
.role=access
firewall.node.allowc2c.wlan1 : allow clients to see each other if
.role=access
firewall.node.allowc2c.wlan2 : allow clients to see each other if
.role=access
firewall.node.allowc2c.wlan3 : allow clients to see each other if
.role=access
firewall.node.allowc2c.wlan4 : allow clients to see each other if
.role=access
firewall.node.enable : firewall enabled? if not, nothing else
here matters.
firewall.node.tcp.allow.dest : tcp dest ports (space separated)
to allow to this node
firewall.node.tcp.allow.source : tcp source ports (space
separated) to allow to this node
firewall.node.udp.allow.dest : udp dest ports (space separated)
to allow to this node
firewall.node.udp.allow.source : udp source ports (space
separated) to allow to this node
2.5.9 ‘ping’ command
Syntax
ping <IP address or hostname>
Description
Pings a remote network device. Halt pinging with Ctrl+C
Example
ping 172.29.1.1