User's Manual

EnRoute500 User’s Guide
TR0149 Rev. C5
68
The values for ‘txpower’ in the ‘wlanN’ interfaces must be no greater than the
values listed in Table 11 to be in compliance with FCC regulations. Note that
the power limit is dependent on the channel selected.
The example below shows how to set the access point radio’s transmit power.
> use wlan1
wlan1> set txpower=25
The access points transmit power can be set via the web interface using the appropriate
“wlanN” tab on the “Wireless Interfaces” page (see Figure 32).
To determine the currently selected channel for the access point, use the command
‘show channel’ when the appropriate ‘wlanN’ interface has been selected.
Channel txpower setting
1 13
2 – 10 25
11 05
Table 11. Access point transmit power limits
txpower Output Power (dBm)
1 18
10 20
13 22
17 24
21 26
25 28
28 30
Table 12. AP radio output power settings