User's Manual

EnRoute500 User’s Guide
TR0149 Rev. C5
27
3 Using the Web Interface
The EnRoute500 has a web interface accessible through a browser that can also be used to
configure the node and display status parameters.
3.1 Accessing the Web Interface
You can access the web interface by entering one of the node’s IP addresses preceded by
“https://” in the URL field of a web browser (see section 2.1 for a description of how to access
an unconfigured node using its Ethernet interface). When you enter this URL, you will be
prompted for a login and password. The login and password used for the web interface is the
same as for the CLI (see Table 3 in section 2.1).
The node IP must be preceded by “https://”, not “http://”, to access the web interface
Figure 6. Login window for web interface
Since the certificate used in establishing the secure link to the node has not been signed by a
Central Authority (CA), your browser will most likely display one or more warnings similar to
those shown below. These warnings are expected and can be disregarded.