User's Manual

EnRoute500 User’s Guide
TR0149 Rev. C5
16
users can only be set by the ‘admin’ user. The procedure for changing passwords is described
in section 6.1.
2.3 CLI Interfaces
The CLI provides the user with a number of interfaces that contain related parameters and
controls. Some of these interfaces are actual hardware interfaces, such as Ethernet, while
others are virtual interfaces that contain a set of related parameters.
The available interfaces are:
• mesh0 – controls for the mesh radio
• wlan1, wlan2, wlan3, wlan4 – controls for the virtual APs supported by the EnRoute500
• eth0 – controls for the Ethernet interface
• firewall – controls access through the EnRoute500’s network interfaces
• qos – controls Quality of Service (QoS) settings
• version – displays version information for the installed firmware
• system – system settings
The currently selected interface is shown as part of the command prompt. For example, when
the mesh interface is selected, the command prompt will be
mesh0>
After logging in, no interface is selected by default. Before setting or retrieving any parameters,
an interface must be selected.
2.4 CLI Features
The CLI has a number of features to simplify the configuration of the EnRoute500.
2.4.1 Control of the Cursor
The cursor can be moved to the end of the current line with Ctrl+E. Ctrl+A moves it to the
beginning of the line.
2.4.2 Cancel a Command
Ctrl+C cancels the input on the current command line and moves the cursor to a new, blank
command line.