User's Manual

EnRoute500 User’s Guide
TR0149 Rev. C5
11
Interface Description
Power Power input (100-240VAC 50-60 Hz)
Mesh radio port N-type antenna connector for mesh radio
AP radio port N-type antenna connector for access point radio
Ethernet 10/100 Mbit Ethernet interface
Passive PoE PoE secondary power input (9-28VDC, 12W)
Not compatible with IEEE 802.3af
Table 1. EnRoute500 Interfaces
The EnRoute500 is equipped with an auto-sensing Ethernet port that allows both
regular and cross-over cables to be used to connect to it.
Pin Signal Standard Wire Color
1 Tx+ White/Orange
2 Tx- Orange
3 Rx+ White/Green
4 PoE+V Blue
5 PoE+V White/Blue
6 Rx- Green
7 Gnd White/Brown
8 Gnd Brown
Table 2. Ethernet port pinout
The EnRoute500 Ethernet port supports passive Power over Ethernet (PoE). The PoE power
injector should supply an input voltage between 9-28VDC and a minimum of 12W. The pinout
for the Ethernet interface on the EnRoute500 is provided in Table 2.
Attach the supplied antennas to the mesh and access point (AP) radio ports on the
EnRoute500. The antennas used for the two radios are different and it is important to correctly
match the antennas with the radio ports.
The mesh antenna should be attached to the mesh radio port and the access point antenna
should be attached to the AP antenna port, as shown in Figure 5.